Screw fixing method of synthetic resin tile

When people are vigorously promoting the use of resin tiles, we should pay attention to the quality of the products and the installation of the products in the process of selecting resin tiles. In addition to grasping the correct installation procedure, the details are equally important. The following is how to nail the resin tile installation.

1. The resin tile must be drilled first, and then the purlins, otherwise it will cause the resin tile to break.

2. The diameter of the nail is 5.5 mm. The diameter of the pre-drilled hole should be larger than the diameter of the screw, which is about 7.0 mm. The nail should not be too tight. If it is too tight, the tile will bend or break. In addition, a certain space must be reserved to prevent the tile Cracks from occurring when thermal expansion and contraction occur.

3. The nail must be hit on the wave crest, remember not to hit the wrong place.

4. The nails cannot be fixed too loosely, otherwise the roof will leak. The above are some problems to pay attention to when installing and nailing synthetic resin tiles. Resin tile manufacturers recommend using self-tapping nails (wood screws) with a diameter of 6.3mm and a length of 75mm when installing the main tile; when installing the ridge tile and eaves, According to the different fixed positions, choose self-tapping screws (wood screws) of appropriate length, with a diameter of 6.5mm and a length of 110-150mm. Especially when fixing the tiles, remember to install waterproof caps at the end to prevent the screws from rusting and leaking. If there is a phenomenon of drilling dislocation, you can use resin glue and resin powder to make up after mixing.